Landmaschinen-Ersatzteile

Blade holder suitable for Rasspe drum mowers

98x74x3 mm, hole spacing 51 mm

The base funnel is made of hard PVC and gives the protection the necessary strength and durability. The sliding protective tubes are made from high-strength injection molded plastic. The retaining chain prevents the accident protection from rotating together with the drive shaft. (Length is measured from center of cross to center of cross).

AI3070 with two wide-angle flat jets, therefore very suitable for lower spray heights for better use of the droplet energy during deposition.30 jet forward in the direction of travel optimizes penetration in the upper leaf and ear area on the front sides, 70 jet towards the rear covers rear target areas.Drop sizes like short AIXR TeeJet and therefore the perfect compromise between loss reduction and degree of coverage. Large, round, free cross-sections for liquid and air increase operational safety and wear.Plastic designInjector can be removed if necessary.Automatic alignment with Quick TeeJet cap and seal Order No. 72989 Pressure range 1.5 - 6 bar, optimal 2 - 5 bar.Typical applications: Ear treatmentsother fungicides and insecticides in grain, leafy crops and special crops, potato cultivationHerbicides, especially for grasses and rough fields .

Metal wheel 2.0 Basic suitable for many motor mowers up to a weight of 150kg. The metal wheel has a diameter of 420mm (corresponds to rubber tires 4.00 x 8), a width of 190mm and the centering hole has a diameter of 60.5mm. The fastening hub is made with 2 hole circles 4x100mm. A hole circle with the hole diameter for M12 collar screws and a hole circle for fastening with cone screws with a hole diameter of 15mm. The cone rings are welded into the hub.The delivery consists of a pair of metal wheels!The powder-coated metal wheel has a hardened tread on the outer contour and is therefore very resistant to abrasion. Thanks to the nested and welded construction, the wheel is very stable. How it works!Due to the offset outer contour or the overlap of the wheel lugs, a closed radius is created. This creates a closed radius You get perfect concentricity on hard surfaces such as a road without vibrations or shock loads on the driver and drive axles.The design of the wheels ensures a gentle crop flow of the forage from the knife bar right behind the wheels. Due to the geometry of the wheels, there is no wrapping the axles with food. The metal wheels 2.0 are designed in such a way that they clean themselves while driving. When mowing on soft ground, the wheel cleats engage in the ground. By immersing the driving lugs into the ground, the inner radius and the connecting struts are now the new running surface of the wheels. The controlled immersion of the driving lugs creates a uniform linear drive in which there is hardly any pulling to one side - regardless of whether it is on a slope or with uneven meadow vegetation.Another positive effect is the ground footprint that the driving lugs leave by immersing it in the ground. This footprint promotes water absorption on steep slopes. The metal wheel 2.0 Basic is suitable for motor mowers weighing up to 150kg. For heavier mowers, a wider version is recommended. In this case, please contact us or fill out the inquiry form available for download with the required technical data and send it to us. You will then receive a tailor-made offer for the right pair of metal wheels for your motor mower.Scope of delivery: 2 pieces of metal wheels

Skid suitable for Kuhn disc mower type FC and GMD. The skid is painted, tempered and hardened.

Twisted shackle into a mallet or flail knife with an elongated hole.