Agricultural machinery

L = for agricultural vehicles and transport equipment up to 30 km/h, N = for heavy agricultural vehicles over 30 km/h, top quality, at a speed below 30 km/h the permissible axle load for TYPE N increases by 30 - 50%

Ball/gear lever for Steyr Plus series:30, 43040, 540, 545, 54850, 650, 658, 760, 768

10 ohms

Banjo screw for attaching ring eyes and ring soldering pieces

Suitable for ESM universal beams type 30 - 16.

Bar blade with a smooth counter edge suitable for ESM leaf trimmers and Schanzlin vine trimmers. The blade has a length of 110 mm, a width of 70 mm and the hole spacing of the rivet holes is 51 mm. The blade is fastened to the back of the bar with 6x20 mm countersunk rivets.

Underlay for the knife holder to compensate for the height of the beam attachment. This is screwed into the two outer knife holders.

fully insulated

fully insulated, with two cast inserts and ground strap

​​Suitable for long-version battery coversLength: 165 mm

External dimensions 330x188 mm

External dimensions 270x188 mm

12 V/100 A, manual switch for switching + or - lines. Switching key can be removed in the off position, 2 connection screws for 8 mm cable lug, switching current 12/24 V = 100 A, switching current for short-term operation (5 seconds) 500 A.

Switch lever can be removed in the off position, 2 connection screws for 10 mm cable lug, 250 A, short-term operation (5 seconds) 2500 A.

Delivery: 1 pair

High-quality pole grease for secure contact and protection

Simple fixation using a double cable clamp, for cables up to 70 mm

For Multipoint I, with contact sockets and 2 grommets, including assembly instructions.

4-hole mower blade, serrated version, suitable for BCS cutter bars and Reform motor mowers. The rivet holes are countersunk at the bottom with diameter 5,5 mm. The two central holes have a diameter of 10 mm.

Double finger middle cut suitable for Aebi, BCS and Reform

Blade holder for BCS finger mower Europe series 600 and 700. Suitable for Aebi, BCS and Reform.