Suitable for Reform Type RM58, 158, 110, 111, 111S, 112, 115, 116, 131, 316.
Suitable for Steyr T80-180 with cleaning plates
Particularly suitable for drives where there is a larger radial load, e.g. drive via V-belt pulley.Don't forget to order matching drive pinions for the front bearing for the hydraulic pump! You can find these on page 465 at the bottom right.
Front bearing suitable for all oil motors with a 2-hole SAE-A connection and shaft diameter of 25 mm. These auxiliary bearings are used for higher axial loads on oil motors, e.g. due to a chain drive or V-belt drive. Two tapered roller bearings are installed in the bearing.There is an SAE-A 4-hole flange with a shaft diameter of 25 mm on the output side. The tapered roller bearings are lubricated via a grease nipple on the bearing housing.
Front bearing suitable for all oil motors with a 2-hole SAE-A connection and shaft diameter of 25 mm. These auxiliary bearings are used for higher axial loads on oil motors, e.g. due to a chain drive or V-belt drive. Two tapered roller bearings are installed in the bearing.There is an SAE-A 4-hole flange with a shaft diameter of 32 mm on the output side. The tapered roller bearings are lubricated via a grease nipple on the bearing housing.
?The harrow tine is mounted on the seed harrow at the front, viewed in the direction of travel.
LxWxH: 120x80x56 mm, hole spacing 58 mm, suitable for e.g. Case IH, Deutz, Fiat, Ford, John Deere, MF, ...right/left
LxWxH: 120x80x135 mm, 22 slanted mounting plate, suitable for e.g. Case IH, Deutz, Fiat, Ford, John Deere, MF, ... right/left
LxWxH: 85x85x50 mm, M4 screws, hole spacing 45 mm, suitable for e.g. Case IH, John Deere, Fendt, MF, New Holland, ...right/left
suitable for MF, LxWxH: 128x68x48mm, ~Fastening: 2 screws M6, hole spacing: 45mm ?Design: left/right
Fender flares primed, front left for Steyr 8065-8095Width version 220mm
Ausführung: vorne linksBreite: 95 mmFarbe: Rot RAL 3000
No conical nut necessary.
60.4003.800, star profileMade of spring steel 55Si8, partly C45. All tines with tapered nut and quality guarantee.
Square profileMade of spring steel 55Si8, partly C45. All tines with tapered nut and quality guarantee.
Front radiator bracket for Steyr 8080 SK1
Fender flares primed, front right for Steyr 8065-8095Width version 220mm
Version: Painted
